CHIEF MTMPU - Manual (Page 7)

Installation Instructions MTMPU
7
Attaching Upright Brackets to Display
1. Vertically align the center of the uprights (B and C) with
center of screen. (See Figure 5)
NOTE: The diamond-shape opening in the uprights (B and C)
corresponds to the vertical center of the upright.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Using screws of
improper size may damage your display. Properly sized
screws will easily and completely thread into display
mounting holes. If spacers are required, be sure to use longer
screws of the same diameter.
2. Select correct screws, spacers (if necessary) and washers
from the hardware bag (D) and attach brackets to back of
display. (See Figure 5)
Figure 5
Switching Upright Brackets (Optional)
If an installation situation makes adjusting the location of upright
brackets necessary, there are several options.
1. The wall bracket may be adjusted side to side at the points
of attachment (mounting slots). (See Figure 6)
2. The location of the left and right upright brackets may be
switched, with the knobs on the MTMPU upright brackets
facing the inside of the mount. (See Figure 6)
Figure 6
3. If necessary, the tilt upright bracket knobs may be switched
to allow the brackets to be reversed. (See Figure 7)
a. Remove display from mount.
b. Remove brackets from display.
c. Hold the right upright bracket horizontally, tightly gripping
it so that spacers do not move.
d. Remove the knob, washer and screw.
e. Replace the knob, washer and screw in the opposite
order, with the knob on the inside of the bracket.
f. Switch the right upright bracket to the left side of the wall
mount.
g. Repeat Steps 3c through 3f with the left upright bracket.
2
Center of
Upright
(C)
(B)
(D13 or D14)
(D1 - D11) x 4
(D12) x 4
1
2
Knobs
mounting
slot
mounting holes