CHIEF MTMPU - Manual (Page 8)

MTMPU Installation Instructions
8
Figure 7
Attaching Display to Wall Mount
1. Push upright brackets tabs all the way down so that the
lower mounting slot is blocked. (See Figure 8)
Figure 8
2. Hang the top hook of upright brackets onto the top bar of the
mount. The bottom of the display will be away from the wall.
NOTE: Do NOT allow both upright brackets to be located on
same side of wall bracket. (See Figure 9)
NOTE: NEVER place both upright brackets to one side of the
wall mount center line! (See Figure 9)
Figure 9
3. Route cables between wall and bars.
CAUTION: PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
4. Move screen towards the wall by pulling display bottom
away from wall and pushing the upright brackets tabs up
one notch to the detent which you will be able to feel.
(approximately half way up). (See Figure 8)
5. Push bottom of display toward the wall bracket so that lower
latch on upright brackets surrounds lower bar of wall mount.
6. Raise upright brackets tabs all the way to secure the
brackets onto the wall mount. (See Figure 8)
3d
3e
Knobs to outside
of brackets
4
1
6
Latch
open
Latch
closed
Upright bracket tab
Mounting Slot
Blocked
center line (CL)
Both upright brackets must NEVER be located
to one side of the wall bracket!
NEVER place both upright brackets to one
side of the wall mount center line (CL)!