CHIEF PCM Series - Manual (Page 5)

Installation Instructions PCM Series
5
Mount Assembly and Installation
IMPORTANT ! : These installation instructions assume
that the Listed fixture (coupler or ceiling plate - not
included) has 1 1/2” NPT or NPSM threads following
ANSI/ASME B1.20.1, and has been properly installed
and is in place.
1. Fold column out until column mounting bracket rests
against faceplate mounting bracket. (See Figure 1)
2. Secure column against faceplate mounting bracket using
3/16” hex wrench (C) and two 5/16-18 x 1/2” button head
cap screws (D). (See Figure 1)
3. Tighten all hardware.
Figure 1
4. Thread the column assembly (A) into fixture (coupler or
ceiling plate - not included), with a minimum of four threads
engaged.
5. Secure faceplate (B) to faceplate mounting bracket using
3/16” hex wrench (C) and four 5/16-18 x 1/2” button head
cap screws (D). (See Figure 2)
Figure 2
Display Installation
1. Attach PSBU interface bracket (not included) to the display
following instructions included with the interface bracket.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Displays can weigh in
excess of 40 lbs (18.1kg). ALWAYS use two people and
proper lifting techniques when installing display.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT. Make sure mounting buttons
on display are properly seated in mounting holes in faceplate.
2. While supporting both sides of display, align four mounting
buttons on interface bracket with four mounting holes in
faceplate. (See Figure 3)
3. Lower display into place listening for audible “click” to ensure
recessed area of mounting buttons are properly seated in
lower area of mounting holes, and “click lock” mechanism
has engaged. (See Figure 3) and (See Figure 4)
Figure 3
1
(D) x 2 2
Faceplate mounting
bracket Column
5 (D) x4
(B)
(A) 2
1