CHIEF MWRIW Series - Manual (Page 9)

Installation Instructions MWRIW Series
9
ADJUSTMENTS
Pitch Tension Adjustment
To adjust display pitch tension:
1. With display installed, tighten or loosen two screws, one on
each side, using the 5/32” hex wrench. (See Figure 7)
2. Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained.
Figure 7
Roll Adjustment
The MWRIW allows for the horizontal alignment (Roll) of the
display to be adjusted up to 2° right or left to level the display
after installing.
To adjust Roll:
1. Loosen the roll tension adjustment nut located on the back
side of the faceplate assembly. (See Figure )
2. Level display.
NOTE: If display will not level slightly loosen top nut as
well.
3. Tighten roll tension adjustment nut. (See Figure )
Figure 8
x 2
2
1
2
1
3