Hunter 99164, 99165, 99166 Traditional Globe Light Kit - Manual (Page 8)

MA022-01 • 03/07/14
1.888.830.1326
8
TYPE-C ASSEMBLY INSTRUCTIONS
Using the single pin connectors,
connect the black or blue wire from the
fan to the black wire from the light kit.
Connect the white wire from the fan to
the white wire from the light kit.
Feed the wires through the center hole in
the switch housing, the washer, and the
nut. Then install the switch housing by
twisting clockwise onto the threaded rod.
Install the washer and nut onto threaded
rod and tighten securely.
Lift the light kit assembly up so that the
screw holes in the lower switch housing
line up with the holes in the upper switch
housing. Install the switch housing
screws and tighten securely.
3
Switch
Housing
Screw
Wire
Connector
Switch
Housing
If your fan does not have pin connectors
on the wires coming from the switch
housing, install the wiring harness
provided. Using the provided wire
connectors connect the white wire from
the fan to the white wire from the wire
harness and connect the black or blue
wire from the fan to the black wire from
the wire harness.
Do not allow the light kit to hang
only by the wire connections!
4
1 2