Hunter 28704 52 Skyline - Manual (Page 9)

9
42449-01 • 11/09/10 • Hunter Fan Company
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wall switches are not included . Select an acceptable general-use switch
in accordance with national and local electrical codes .
4-1 . Before attempting installation, make sure the power is still off .
4-2 . To connect the wires, hold the bare metal leads together and place
a wire connector over them, then twist clockwise until tight . For
all these connections use the wire connectors provided .
4-3 . Connect the bare or green ground wire (grounding) from the
ceiling to the green ground wire (grounding) from the ceiling plate
and the green ground wire from the fan .
4-4 . Connect the white wire (grounded) from the ceiling to the white
wire (grounded) from the fan .
4-5 . Connect the remaining wires as follows:
Dual Switch Wiring:
• The black wire (ungrounded) from the ceiling to the black wire
(ungrounded) from the fan
• The black/white wire (ungrounded) from the fan to the wire
(ungrounded) for the wall switch
Single Switch Wiring:
• The black wire (ungrounded) from the ceiling to the black
(ungrounded) and the black/white wire (ungrounded) from
the fan
CAUTION: Be sure no bare wire or wire strands are visible after
making connections .
4-6 . Turn the splices upward and push them carefully back through the
ceiling plate into the outlet box .
4-7 . Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the
outlet box .
Dual Switch Wiring
Single Switch Wiring
Wire
Connector
4 • Wiring the Fan