Hunter 28704 52 Skyline - Manual (Page 12)

12
42449-01 • 11/09/10 • Hunter Fan Company
Your Hunter fan comes with an integrated light fixture assembly and
an optional switch housing cap and plug button . This feature gives
you the option of installing the fan with OR without the included light
fixture . The steps below direct you whether or not you are installing a
light fixture .
WARNING: Use only the light fixture supplied with this fan model .
7-1 . To attach the upper switch housing, partially install two housing
assembly screws into the switch housing mounting plate .
7-2 . Feed the upper plug connector through the center opening of the
housing .
7-3 . Align the keyhole slots in the housing with the housing assembly
screws .
7-4 . Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole slots .
Install the remaining screw into the housing . Tighten all three
screws firmly .
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate . Failure to properly
attach and tighten all three assembly screws could result in the
switch housing and light fixture falling .
7-5 . If you want to install the light fixture, proceed with step 7-6
now .
If you do not want to install the light fixture, you need to
uninstall it now . See “Uninstalling the Light Fixture” on step 7-14 .
Once you have uninstalled the light fixture, continue with step 7-6 .
Steps 7-1 – 7-3
Housing
Assembly
Screw
Upper
Switch
Housing
7 • Completing Your Installation With or Without a Bowl Light Fixture