Hunter 59009 52 Allegheny Low Profile User Manual

Page 13

42221-01 • 06/04/12 • Hunter Fan Company

Step 7-9

Steps 7-12 – 7-14

7 • Completing Your Installation With a Bowl Light Fixture (continued)

Connector

Step 7-10

Step 7-11

7-9. Install E-26 60 watt light bulb. When necessary, replace with bulb of the

same wattage.

Note: The reversing switch is located on the switch housing. It can only

be accessed when globe is removed.

Attaching the pull chain pendants:
7-10. Feed the pull chains from the fan switch and the light switch down

through the holes in the upper switch housing. (You may find a
connector on the end of the pull chain. If so, remove and dispose of it. )

7-11. Attach the pull chain pendants to the light and fan pull chains using

the connector.

Installing the globe:
7-12. Position the indentations in the outer rim of the globe so that they line

up with the tabs on the inside surface of the light fixture rim.

7-13. Carefully lift the globe up inside the light fixture as far as it

will go.

7-14. Rotate the shade in a clockwise direction until it is held tightly in place

by the three tabs.

Globe

Bulb

Reversing

Switch

Pull Chain

Pendant

Fan

Light