J&M Talc Applicator Set Up For Seed Tender 275 & 375 - Manual (Page 2)

Step 1.
Measure from the top of the shell frame and make a mark on the front right side leg at 35” for the Model 375
Seed Tender and 42” for the Model 275 Seed Tender. This mark is for the height of the Talc Holding Container.
Next using the Talc Holding Container as a guide, mark 2 holes on the side of the leg. Drill both holes with a
7/16” bit. Once the holes are drilled, fasten the Talc Holding Container with (2) 3/8”x 1” Serrated Flange Hex
Nuts and Bolts. Tighten the hardware once finished.
Step 2.
Using the Talc Control Valve Body Assembly mark (2) holes in the front left leg gusset. The bracket should be
placed at the highest point possible on the front leg gusset. Once marked, drill 2 holes with a 7/16” drill bit.
Attach the Control Valve Body Assembly with (2) 3/8” x 1” Serrated Flange Hex Head Nuts and Bolts. Tighten
hardware once finished.
42” (275ST)
35” (375ST)