J&M Case IH-8010 - Manual

Combine Grain Tank Set-Up Instructions
for Case AFX 8010 Series Combines
Assembly Instructions
Step One:
Remove 5/16” bolts in the combine cab that may interfere
with the placement of the grain tank framing members.
Place frame halves on combine hopper. Loosely fasten frame
halves combine hopper using one of the following options:
Option One: If combine has hex nuts welded to the top of
the combine at the front and rear frame members, simply
align the welded hex nuts with two of the cut-outs in the front
and rear frame and secure to the top of the combine using
four 8.8 x 2 1/4” hex bolt and heavy washer.
Option Two: If combine does not have hex nuts welded
to the top of the combine at the front and rear frame members,
align the front and rear frame members with the adjacent
holes in the top of the combine and secure using eight 3/8” x
2 1/2” Bolts and 3/8” Flange Nuts.
Step Two:
Fasten Tubing Rails (Note: Left side tubing rail has cut-outs
on the underside of the tube) to frame halves using four 3/8”
x 4” bolts with 3/8” lock nuts. Using self tapping screws,
secure the tubing rails (through the hinge hole) to the top of
the combine to prevent frame from lifting when panels are
folded.
Step Three:
Attach the corner panels to the hinges on the front and rear
frames as shown using eight 3/8” x 4 1/2” Bolts and 3/8”
Lock Nuts.
Fold this Panel First
Lanyards and
Lynch Pins shown
below are typical
on Front, Rear and
Side Panels
# Part # Description Qty
1 CIH-CP8010 Corner Panel 4
2 CIH-FRP8010 Front/Rear Panel 2
3 CIH-LRP8010 Left/Right Panel 2
4 CIH-FRF8010 Front/Rear Frame 2
5 CIH-TR8010L Tubing Rail (left w/cut-out) 1
5 CIH-TR8010R Tubing Rail (right) 1
6 CTE-PP Plastic Plug 8
7 CTE-PL Plastic Lanyard 24
8 CTE-LP Lynch Pin 24
9 HB-38212 8.8 x 2 1/4" Hex Bolt w/Heavy
Washer and Nut (opt.) 4
9 HBN-38212 3/8" x 2 1/2" Bolt w/ Flange Nut 4
10 HB-384 3/8" x 4" Bolt 8
11 HB-38412 3/8" x 4 1/2" Bolt 8
12 6MM-475 6MM Bolt x 4 3/4" (8.8) 8
13 LN-38 3/8" Lock Nut 8
14 6MM-NLN 6MM Nylon Lock Nut 8
15 FN-38 3/8" Flange Nut 10
16 IW-71212 Inspection Window 4
17 62095-7 Window Molding 4
18 PCS-316100 Panel Chain Support 1
19 FB-381 3/8" x 1 Flange Bolt 2
20 CTE-SS1 Step 1
21 34STS Self Tapping Screw 8
22 CIH-HR8010 Handrail 1