J&M JD-Walker 2001 and older - Manual

Combine Grain Tank Set-Up Instructions
for John Deere 9400, 9410, 9500, 9510 and 9550 Walker Series Combines
(model year 2001 and older) Lanyards and
Lynch Pins
shown below
are typical on
Front, Rear
and Side
Panels
Sensor Mounting Bracket,
Hardware and Sensor
Extension Wire
Assembly Instructions
Step 1:
Attach rear brace (10) to outside left corner of combine tank as
shown.
Remove corner bolts,
position new brace
making sure point A
rests on grain tank
brace point B, then
reinstall corner bolts
securing new brace to
grain tank.
For second brace installation, locate flange C on inside rear
wall of grain tank. Position new Rear Center Brace (9) on the
side of the flange nearest the ladder. With the notch on the top
of the new brace, under the top lip of the grain tank, and flush
with the side of the tank flange, mark and drill 5/16” holes.
Secure new brace with 5/16” flange bolts and flange nuts in the
top two holes in the flange and the bottom hole with 5/16” flange
bolt and nut.
# Part # Description Qty
1 JD-CP1 Corner Panel 2
2 JD-CP2 Corner Panel 2
3 JD-FRP-95
JD-FRP-96 Front/Rear Panel (9500)
Front/Rear Panel (9600) 2
2
4 JD-LRP Left/Right Panel 2
5 JD-LF-NS Left Frame 1
6 JD-RF Right Frame 1
7 JD-AR-95
JD-AR-96 Angle Rail (9500)
Angle Rail (9600) 2
2
8 JP-CP Cover Plate 1
9 JD-RCB Rear Center Brace 1
10 JP-RB Rear Brace 1
11 JD-SMB Sensor Mounting Bracket 1
12 CTE-PP Plastic Plug 8
13 CTE-PL Plastic Lanyard 16
14 CTE-LP Lynch Pin 16
15 JD-EW Extension Wire 1
16 HB-38412 3/8" x 4 1/2" Bolt 8
17 6MM-475 6MM x 4 3/4" Bolt (8.8) 8
18 FB-381 3/8" x 1" Flange Bolt 16
19 FB-51658 5/16" x 5/8" Flange Bolt 9
20 LN-38 3/8" Lock Nut 12
21 6MM-NLN 6MM Nylon Lock Nut 10
22 DS-1434 1/4" x 3/4" Drill Screw 4
23 IW-71212 Inspection Window 4
24 62095-7 Window Molding 4
25 FN-516 5/16" Flange Nut 9
26 FN-38 3/8" Flange Nut 6
27 CTE-SS1 Step 1
A
B
C
Drill