J&M GRAIN CARTS Leaner Setup - Manual (Page 10)

-9-
NOTE: This is a general list of parts for a leaner with tarp, so some of these will be already installed
on arrival or installed in sideboard set up. The purpose of this list here is to provide a visual aid along
with the previous page.
Detail # Description Quantity
1 Tarp crank handle 1
2 1” schedule 10 x 198” long pipe 1
3 1” x 1” 14ga x 192” long square tubing 1
4 Drip edge 1
5 Spring Return 1
6 Rear End Cap (Bolt Together, No Wind Lip) 1
7 Front End cap (Bolt Together, Wind Lip) 1
7-1 Rear Short End Cap (BT, NWL, 4’ Long) 1
7-2 Front Short End Cap (BT, WL, 4’ Long) 1
8 *Bows
1326’s 8
1000’s,1050’s, 1150’s 7
620’s, 750’s, 875’s 4
525’s 3
9 3/16” Diameter Ridge Cable 3
10 3/8”-16 Centerlock Hex Nut 11
11 3/8”-16 x 2” Hex Bolt 5
12 Stop Bracket 3
13 1/2”-13 x 1 1/4” Hex Bolt 1
14 1/2”-13 Centerlock Hex Nut 1
15 Hanger bracket hook 1
16 Hanger bracket 1
17 3/8”-16 x 1” Serrated Flange Hex Bolt 17
18 3/8”-16 Serrated Flange Hex nut 17
19 Cable clamp 6
20 1/4”-20 Centerlock Hex Nut 9
21 1/4”-20 x 3/4” Serrated Flange Hex Bolt 4 per Bow
22 Unviersal joint 1
23 1/4”-20 x 2 1/2” Hex Bolt 1
(Parts Not Shown)
24 1/4” x 3/4” Self Tapping Bolt 10
25 1/4” drive rivet 8
26 Canvas tarp 1
27 Plast End Cap Rail Attachment 1
28 1/4” x 1 1/2” Self Tapping Bolt 4
29 1/4” x 5/8” Button SKT Cap Screw Zinc 5
30 1/4” x 1/2” Button SKT Cap Screw Zinc 22
31 1/4” Serrated Flange Nut Hard & Zinc 27 + 4 per Bow
32 Plastic J&M Standoffs 2
33 J-bolts 6
34 Prop Up Bar (2 Piece) 2
35 1/4”-20 x 3/4” Hex Bolt 8
LEANER MODEL GRAIN CART TARP INSTALLATION