Adcom GTP-760 - Manual (Page 26)

BUTTON FUNCTION
Main CD Tuner All Others
0 Not programmable Track 10 Programmable Programmable
+ 10 Not programmable + 10 Programmable Programmable
SHIFT Not programmable Call Presets 8 - 14 Programmable
FM/AM Not programmable Repeat FM or AM select Programmable
STEREO Stereo mode select Program/Mem. Stereo/Mono Programmable
SRND Surround mode select Random play Programmable Programmable
ENTER Not programmable Time display Seek/Manual Programmable
D. RANGE Dynamic range adjust Disc 1 Programmable Programmable
REAR + Rear level up Disc 2 Programmable Programmable
CENTER + Center level up Disc 3 Programmable Programmable
SUB + Subwoofer level up Disc 4 Programmable Programmable
BAL. CHK Balance check Disc 5/Memory clear Programmable Programmable
DIALOG Dialog enhance on/off A-B repeat Programmable Programmable
REAR - Rear level down Clear repeat Programmable Programmable
CENTER - Center level down Programmable Programmable Programmable
SUB - Subwoofer level down Programmable Programmable Programmable
DIM Dim display Programmable Dim Display Programmable
M1 For Macro use For Macro use For Macro use For Macro use
M2 For Macro use For Macro use For Macro use For Macro use
M3 For Macro use For Macro use For Macro use For Macro use
M4 For Macro use For Macro use For Macro use For Macro use
ROOM 2 Room 2 source select Programmable Programmable Programmable
MUTE Mute volume Mute volume Mute volume Programmable
PROGRAMMING YOUR ADCOM GTP-760 REMOTE CONTROLLER
Introduction
The ADCOM universal remote controller operates eight different audio/video components. As you’ve already
seen, it’s preprogrammed to control ADCOM’s GTP-760 Preamp/Tuner and the GCD-700 CD player. In addition,
it has five “component memory banks” available so you can program the remote to learn commands for your
DVD player, satellite box, laserdisc player, VCR, etc. This lets you use one remote controller for your
entire system.
Using Preprogrammed Commands
Using the remote controller’s preprogrammed commands is simple. For most GTP-760 functions (volume up/
down, changing surround modes, etc.), follow these easy steps.
1. Press the main source selector button. This tells the remote that you want to use GTP-760
preprogrammed commands. The main button will flash red to tell you it understands.
2. Press the appropriate function button (volume up, volume down, etc..) If you’ve selected a button
that actually triggers a GTP-760 command, the main button will again flash red to confirm your choice.
If the main button does not flash, you’ve selected a function button that isn’t preprogrammed.
(Review the table above to see which buttons are preprogrammed.)
25