Castle LB-23 Operator Manual - Manual (Page 5)

Setting Up Your LB-23
Your Castle LB-23 system drill was set up and tested for proper operation at the
factory. It is normal to find a small amount of sawdust residue in the machine
from this process.
ƒ Begin set-up by unwrapping and installing the side stop extensions for
your machine. On either side of the yellow guard you will find two hex
head bolts with T-nuts. Loosen these bolts and slide the side stops on.
ƒ The yellow stop on the side-stop should point to the drill bits.
ƒ Tighten the hex heads.
ƒ Next, hook up the air to the machine. On the right side of the machine
you will find two regulators and two brass fittings.
ƒ
The brass fitting towards the rear is the air inlet. You will want to attach
air to the machine at this inlet.
Caution: do not over tighten
coupler to fitting.
3