Castle TSM-21 Serial 61076 to 64233 (Parker) Operator Manual - Manual (Page 12)

ƒ The Motor Carriage on your machine is secured against movement during shipping.
Open the rear door and look toward the top of the machine just left of center for the black
Router Stop Plate. Cut the zip tie that secures the yellow Motor Carriage to the Router
Stop Plate and let the carriage move forward to its neutral position. Inspect the T-
Knobs and the U-Bolt on the carriage (Figure 3), making sure that the motors are secure
and tight.
Figure 3 Figure 4
ƒ Using the wrenches located inside the rear of the machine make sure the router bit and
the drill bit are secure in the respective collets.
ƒ Install the Work Top with the 4 flat head bolts and nylock nuts supplied. (Figure4)
ƒ From the rear of the machine rock the carriage fully forward and backward, by hand,
mimicking its working motion. Make sure that nothing is blocking the motion of the
carriage or the cutting bits.
10
ƒ Plug the machine into a grounded 115VAC, 20-amp outlet.