Installing the receiver 5, Connecting the receiver to an hdtv 5, Installing the receiver – Actiontec SBWD100A User Manual User Manual

Page 6: Connecting the receiver to an hdtv

Installing the Receiver

This chapter explains how to connect the ScreenBeam Pro Wireless

Display Receiver to an HDTV monitor. Make sure you have all the

contents from the Receiver’s package available before starting.

Connecting the Receiver to an HDTV

To connect the Receiver to an HDTV monitor:
1. Get the Receiver, power cord, and HDMI cable from the

ScreenBeam Pro package.

2. Plug one end of the supplied HDMI cable into the HDMI port on

the Receiver, and the other end into an available HDMI port on the

HDTV.

3. Plug one end of the power cord into the Receiver, and the other end

into a power outlet. When Steps 1, 2, and 3 are complete, the

hardware should be connected as shown in the figure, below.

Note: The power outlet and cable may appear different than those shown

in the figure.