Actiontec MWTV200R Installation Guide - Manual

MyWirelessTV allows you to place an HDTV anywhere in your
home because it transmits your video and audio wirelessly.
Use this Receiver to connect an additional HDTV to your existing
MyWirelessTV HD Transmitter.
Congratulations! You have successfully paired the new Receiver
to the existing Transmitter.
A How MyWirelessTV Works
Step
2
Plug the smaller end of the
power supply into the 5VDC port on
the back of the Receiver.
Step
3
Plug the larger end of the
power supply into a power outlet.
Step
1
Get the power supply and
Receiver from the box and place them
near the existing MyWirelessTV HD
Transmitter.
B Pair New Receiver to Existing Transmitter
Step
2
d
Turn on the HDTV near the Receiver. Make sure you
have selected the correct source input on the TV. You should be
able to see video from the source device.
Step
4
Make sure the Power Light
on the Receiver is SOLID Green.
Step
7
Wait 40-45 seconds. The Power Light on the Receiver
should be SOLID Green and the Sync Light on the Receiver
should be Blinking Green.
Step
5
Press the Sync button on the
new Receiver for at least 5 seconds.
Step
6
Now press the Sync button
on the existing Transmitter for at least
5 seconds.
Step
1
b
Plug the smaller end of the
power supply into the 5VDC port on
the back of the Receiver.
Step
1
c
Plug the larger end of the
power supply into a power outlet.
Step
1
a
Unplug the new Receiver
and its power supply. Go to the HDTV
that you want to connect.
Step
1
d
Make sure the Power Light
on the Receiver is SOLID Green.
Step
1
e
Wait 30-45 seconds. The
Power and Wireless Lights should be
SOLID Green, and the Sync Light
should be Blinking Green.
Flip this Quick Start Guide over to continue
NEXT
Note: Only use power adapter, Leader Electronics Inc., Model MU12-G050200-A1
Note: If the Sync Light is SOLID Orange, wait another 10-15 seconds. It should turn
GREEN. If the Sync Light stays SOLID Orange you will need to manually pair the units
again. If the Sync Light is Blinking Red the units can’t connect or are out-of-range.
RECEIVER
MWTV200R
(Optional)
HDTV
POWER
OUTLET
1
2
3
Please refer to
this illustration
while connecting
cables
Step
2
a
Get the HDMI cable from
MyWirelessTV Kit.
Step
2
b
Plug one end of this HDMI
cable into an HDMI port on the HDTV.
Step
2
c
Plug the other end of the HDMI
cable into the HDMI Out to TV port on
the back of the Receiver. The HDTV
should now be connected to the Receiver.
CAUTION
Do NOT place the MyWirelessTV
Receiver on top of or near a
heat-generating source.
C Connect the Cables
MWTVrx_QS3_QS sngl pnl 9/13/11 4:40 PM Page 1