Actiontec SBWD100A User Manual - Manual (Page 14)

Display and Control Options
This chapter describes the various display options offered by different
manufacturers and operating systems that are supported by the
ScreenBeam Pro Wireless Display Receiver.
Display Mode
The Receiver supports three display modes when connected with a
compatible wireless display application (Intel WiDi or Windows 8.1
Project, for example). In Windows, select Display mode by pressing the
Windows logo + P keys simultaneously and selecting the appropriate
mode from the “Options” menu.
Duplicate
Duplicate mode is used to display the same content on both the device’s
screen and the HDTV simultaneously.
Note: There may be a minor delay between the display showing on the
HDTV screen compared to the device screen. This is due to the current
state of wireless display technology.
Extend
Extend mode creates a single, extended “screen” between the source
device and the HDTV. When in Extend mode, dragging windows to right
side of the device’s screen displays those windows on the HDTV, while
dragging windows to the left of the HDTV screen displays them back on
the device’s screen. This mode allows users to display selected content on
the HDTV, while all other windows remain on the device’s screen. When
this mode is first selected, the HDTV displays only the Windows desktop.
13