PA Industries Transporter - Manual (Page 14)

14
Reassemble in reverse order, using caution not to bend
the Valve Disc Assembly.
1. Remove the Air Regulator Rod T40-029 by loosening
the set screw in the top of the Slide Frame and slide the
rod out. If the slide is deformed, it must be replaced.
2. Remove the two (2) Flathead Screws, which secure the
Stop Washer T40-027 to the Slide Frame. Remove Nut
T40-072 from back of Piston. Remove the Slide Frame.
3. Remove the Top Plate T40-006 which holds the Air
Regulator T40-608 and Felt Cover T40-009. Check
the Regulator O-Ring T3-407 (14208-008) for damage.
4. Remove the Air Line from Fitting T40-605. Remove the
Plug T40-601 and check the Plug O-Ring T40-037.
5. Remove Air Inlet Cap. Check O-Ring for damage.
6. Remove the eight (8) Flathead Screws T10-210 from
the bottom mounting plate and slide the Piston
Housing away from the body.
7. Remove the Valve Disk T40-010 by unscrewing the
Valve Disc Screw. Hold a 3mm hex wrench at the
Valve Rod Washer T40-017 to prevent rotation. It is
now possible to take out the Piston T40-019.
8. To remove the Valve Rod and Disk Assembly T40-603
from the Piston, hold the exposed Valve Disc gently in
a vise. Use the 3mm Hex Wrench and remove the
screw.
9. Replace the Long Valve Spring T40-047 and the
Short Valve Spring T40-046.
Factory Repair & Rebuild Service
Return the Transporter by UPS Prepaid to our repair center.
After teardown and inspection, P/A Industries will notify you
of the recommended cost for spare parts and labor.
MODEL TP-40 SERVICE
Disassembly
Reassembly