PA Industries Magnum Servo Roll Feed SRF-M12/18/24/32/36/48 - Installation Manual - Manual (Page 10)

ULTRA MAGNUM SERVO ROLL FEED 2 /14/2003
10
press through another stroke, verifying that things are happening at the correct time (Roll Release, etc.). If the
system is operating properly, you can make a few more “hits”, checking your parts.
1.6 RUNNING THE FEED
Put the Ultra Magnum into “Auto” mode and press the Cycle Start button. The Ultra Magnum
Servo Roll Feed will now follow the press until it is stopped by the Operator, counter,
emergency stop, or feed error.
TYPICAL 180 DEGREE FEED ANGLE
(FROM 260 DEGREES TO 80 DEGREES):
FIGURE 5