DE-STA-CO Rite-Link Conveyors 75mm, 115mm and 150mm LINKS - Manual (Page 4)

SPARE PARTS
Individual components may be purchased in any quantity by specifying the serial number of the conveyor –
located on the saddle plate within the sprocket guard – and referencing the parts as listed in this service manual.
NOTE: The part numbers for your specific conveyor may vary from the part numbers in this manual. Always
provide the serial number of your conveyor when ordering parts so we may provide the correct parts for
your equipment.
BEFORE STARTING
Before starting disassembly of your CAMCO unit you should read and review the following instructions. These
provide important information on parts and procedures necessary to successfully complete your repair.
Comply with all WarningsandCautions.
Read the “Trouble Shooting Guide” section of your General Service Manual before disassembling CAMCO units.
DE-STA-CO recommends returning defective equipment for inspection and repair whenever possible.
DE-STA-CO uses Loctite TM adhesive to secure all screws and set screws. If you encounter a fastener that is
difficult to remove, apply heat to the screw and remove while still warm.
3