Bird B Gone Bird Jolt Flat Track - Manual (Page 6)

Inc.
®
R
(800) 392-6915
6
Bird Jolt Flat Track™
Snug Fit Corner Connectors:
If you determine you need to make a 90° angle with the track, the best solution is to install a Snug
Fit Corner Connector (BJFT-SFCC).
® At the end of the track, cut the track at a 45°
angle with the shortest side facing the direction
you plan to turn.
® Place the track in the base of the Snug Fit Corner
Connector.
® Using a new piece of track that will be continuing
in the new direction, cut the track at a 45° angle
with the shortest side facing the direction the
track is coming from.
® Place the track in the base of the Snug Fit Corner
Connector so that the tracks are touching and
pressed against each other.
® Snap the top of the Snug Fit Corner Connector in
place (apply pressure to ensure full contact with
pins and track) and apply a dollop of glue on the
outside to seal.
® Be sure to glue the Snug Fit Corner Connector
down to the surface and then continue to glue
down the track.
Corner Connector