Brickcom MD-300N User Manual
Page 17
- 14 -
Hardware Reset
The Reset Button can be used to reboot the camera or restore it to factory default settings. If
the camera experiences a problem, rebooting the camera may correct the problem. If the
problem remains, please restore the camera to factory default settings and reinstall the
software.
To Reboot - Press and hold the Reset Button for one second using a paper clip or thin object.
Wait for the camera to reboot.
To Restore
– Press and hold the Reset Button for ten seconds until the LED light turns off.
When successful restored, the LED will be blue during normal operation.
NOTE: By restoring the camera, all settings will be restored to the factory default settings.
Micro-SD/SDHC Card Capacity (*)
The network camera is compatible with Micro-SD/SDHC (Maximum 32GB) cards.