Brickcom FB-series - Manual (Page 11)

10
Hardware Reset
The Reset Button can be used to reboot the camera or restore it to factory default settings.
If the camera experiences a problem, rebooting the camera may correct the problem. If
the problem remains, please restore the camera to factory default settings and reinstall
the software.
To Reboot - Press and hold the Reset Button for one second using a paper clip or thin
object. Wait for the camera to reboot.
To Restore
– Press and hold the Reset Button for ten seconds until the LED light turns off.
When successful restored, the LED will be blue during normal operation.
Note - By restoring the camera, all settings will be restored to the factory default
settings.
SD Card Capacity (*)
The network camera is compatible with SD/SDHC (Maximum 64GB) cards.
(*) These are optional features. Please refer to the Product List for the full list of
optional features that are available for this product
Reset Button