haier HSU-09RS03_R2(SDB) - Manual (Page 8)

Before going to bed,you can simply press the SLEEP
button and unit will operate in SLEEP mode and bring
Comfortable SLEEP
you a sound sleep.
Press SLEEP
Operation Mode
1 hours after SLEEP mode
O C
SLEEP
operation starts SLEEP
operation stops
1 hr
Rises 1 O C
Rises 1 O C
Unit stop
In COOL, DRY mode
1 hr
1 hours after SLEEP mode starts,temp will become 2 O C
SLEEP
operation starts
SLEEP
operation stops
1 hr
1 hr
3 hrs
3 hrs
Rises 1 O C
Temp.setting Unit stop
In HEAT mode
Decreases 2 O C
Decreases 2 O C
3.In SMART mode
the machine will be in the state of timing-on,if the two
modes are set up at the same time, either of their
4.When quiet sleeping function is set to 8 hours the
quiet sleeping time can not be adjusted.When TIMER
function is set,the quiet sleeping function can't be set
TIMER function, the sleeping function will be cancelled;
automatically, and the other mode will be cancelled.
Power Failure Resume Function
If the unit is started for the first time, the compressor
Note to the power failure resume:
press the sleep button ten times in five seconds and
enter function after hearing four sounds.And press
the sleep button ten times within five seconds and
Temp.setting
Approx.6hrs
SMART
AUTO
AM
The unit operates in corresponding sleep mode, which
adapted to the automatically selected operation mode.
Operation
1.In COOL,DRY mode
starts, temp.will become 1
higher than temp.setting. After
by 1 further. The unit will run
Temp.is higher than temp.
setting so that room temperature
for further 6 hours then stops
won’t be too low for your sleep.
O C
2.In HEAT mode
lower than temp.setting. After another 1 hours, temp
decrease by 2 further. After more another 3 hours,
temp. rises by 1 further. The unit will run for further
3 hours then stops. Temp. is lower than temp. setting
so that room temperature won’t be too high for your
sleep.
O C
O C
another 1 hours, temp. rises
button.
up.After the sleeping function is set up,if user resets
operation time is ended first ,the unit will stop
will not start running unless 3 minutes have elapsed.
unit will run automatically, and 3 minutes later the
When the power resumes after power failure, the
compressor starts running.
leave this function after hearing two sounds.
8