B&K Precision 1688B - Manual - Manual (Page 28)

26
5.2.5 Settings
Use this tab to configure your settings.
Figure 12 - Settings Configuration
Data Log Sampling Time: You can select your desired data log sampling time from 1
second and up.
Voltage Upper Limit (UVL) Setting: You can set your output voltage upper limit value
to safeguard your low voltage applications.
Current Upper Limit (UCL) Setting: You can set your output current upper limit value
to safeguard your low current applications.
5.2.6 Command Set
Note: In order to use remote commands, please make sure to use the following
communication settings - Baud rate: 9600, Data bits: 8, Parity: none, Stop bits: 1. If
you are using HyperTerminal, make sure to check your ASCII setup to not append line
feeds.