4 tool and work area set-up – Autel Maxivideo MV201 User Manual

Page 18

Battery Charging Precautions

Tool Inspection

assembled for the cable to be waterproof.

 Check if the warning label is present, firmly attached and

readable. Do not operate the tool without the caution label.

 Turn on the power and make sure the tool model through the

splash screen and then display the live screen.

 If the tool does not work well after turning it on. Please have the

tool checked by a qualified technician. Any tool that cannot be
controlled with the power button is dangerous and must be
repaired.

NOTE: Please check following methods to avoid injury.

 FOR WALLS:

For inspecting the inside walls, be sure to shut

off the circuit breaker to the whole house before using the tool.

 FOR PIPES:

If you suspect a metal pipe could contain an

electric charge, have a qualified electrician to check the pipe
before using.



FOR AUTOMOBILES: Be sure the automobile is not running
during inspection. Metal and liquid under the hood may be hot.
Don’t get oil or gas on the imager head.

5.4 Tool and Work Area Set-Up

CAUTION: Set up the tool and work area according to these
procedures to reduce the risk of injury from electric shock,
entanglement, and other causes and prevent tool damage.

1) Check work area for:

 Sufficient lighting.

 Do not work in area until flammable sources have been

identified and corrected. The tool is not explosion proof and
can cause sparks.

 Do not use the tool while standing in water.

2) Check the area and determine if MaxiVideo

MV201 Digital

Inspection Videoscope is the correct tool for the job.

 Check the access points to the area.

 Check if there is any electric power supplied to the area to

be inspected.