Autel Maxivideo MV301 - Manual (Page 10)

9
remove the battery compartment and then remove
batteries (Fig. 5).
 To install the batteries, remove the battery
compartment and insert four (4) new AA batteries
into the proper slots in the battery compartment.
4) Proper battery orientation is indicated in the battery
compartment.
5) Replace the battery compartment and screw using a
screwdriver to close the battery compartment cap.
3.2 The Imager Head and Cable Installation
To use the tool, the imager head and cable must be connected to
the handheld display unit. To connect the cable to the handheld
display unit, make sure the key and slot (Fig. 6) are properly
aligned. Once they are aligned, finger-tighten the knurled knob to
hold the connection firmly in place.
Fig. 6
Warning: Ensure to only tighten or loosen the knurled knob and not the
shaft
3.3 Accessories Installation
The three accessories include magnet, hook and mirror (Fig. 2).
All are attached to the imager head in the same manner. Hold the