Autel Autolink AL301 User Manual
Page 15
14
1. If you decide to erase the DTCs, Select ―2. ERASE” from the
main menu by pressing the ENTER button.
If the Scan Tool is not connected or no communication is
established with the vehicle yet, then refer to “Reading Codes”
from 1 to 6 at Paragraph 4.1.
2. A message of ―ERASE? YES NO‖ comes up asking for your
confirmation.
3. If you do not want to proceed with erasing the codes, SCROLL
button to exit.
4. If you do wish to proceed to erase the codes, then press the
ENTER button.
5. If the codes are cleared successfully, an “ERASE DONE!”
message will show on the display. Press the ENTER button to
return to the main Menu list.
6.
If the codes are not cleared, then an ―ERASE FAIL!‖ message
will appear. Press the ENTER button to return to the main
Menu list.