American Expedition Vehicles Brute Double Cab Tonneau Cover - Manual (Page 4)

2
2. Drill out the plastic rivets holding inner fenders to fender flares (fig. 3).
3. Carefully remove inner fenders.
Figure 3
III. Mark location for tonneau cover brackets
1. Position brackets as shown (fig. 4) measuring 1/2“ from top of bed.
2. Mark holes using a marker or grease pencil.
3. When all four bracket locations are marked, drill 5/16” holes being careful not to drill through to the
other side of the bed. It is recommended to use a drill stop set to 1/2”.
FRONT
1/2”
Figure 4