American Expedition Vehicles JK High Steer Kit - Manual (Page 2)

PLEASE READ BEFORE YOU START
TO GUARANTEE A QUALITY INSTALLATION, WE RECOMMEND READING THESE INSTRUCTIONS
THOROUGHLY BEFORE BEGINNING ANY WORK. THESE INSTRUCTIONS ASSUME A CERTAIN
AMOUNT OF MECHANICAL ABILITY AND ARE NOT WRITTEN NOR INTENDED FOR SOMEONE NOT
FAMILIAR WITH AUTO REPAIR.
1
INCLUDED PARTS QTY REQUIRED TOOLS
Passenger-side Front Axle Bracket 2 7/8” drill bit for metal
Driver-side Front Axle Bracket 1 High-torque drill motor
Draglink 1 Floor Jack and two Jackstands
Steering Damper 1 or Vehicle Lift with tall Jackstands
Shock Doubler Bracket 2 Torque Wrench (ft-lbs)
These instructions assume you have the following factory parts installed on your JK:
1. JK frame and front axle with all relevant brackets in tact.
2. Front track bar (aftermarket units will work ONLY if they can be adjusted to stock length.
3. Factory steering linkage (tie rod and part of the drag link will be retained.)
4. Rear stabilizer end links (or equivalent length) to use in front.