Alpha Technologies Spill Control Barrier System - Manual (Page 22)

Alpha Industrial Power Spill Control Barrier System
Revision Date: March 18, 2008 MSDS No. ANFC (A)
Installation Manual Page 20 of 25
MATERIAL SAFETY DATA SHEET
1. MATERIAL IDENTIFICATION
ProductName: NOVOLAC FLOOR COATING (RESIN), PART-A
ChemicalFamily: Epoxy Resin Mixture
Company Name: Eastern Resins Corp.
1174 River Street
Woonsocket, RI 02895, USA BUSINESS PHONE:
EMERGENCYPHONE: (401) 769-6700
(800) 255-3924
2. COMPOSITION
Exposure Limits
Chemical Name Wt %
ACGIH
TLV-TWA OSHA
PEL
Epoxy resin Mixture
Titanium Dioxide *
Carbon black*
Specific ingredients are considered a Trade Secret
>70
<10
<1 N/E
10 mg/m3
3.5 mg/m3
N/E
15 mg/m3
3.5 mg/m3
Abbreviations: N/E - NOT ESTABLISHED
* - Materials are in Non-Airborne form
3. HEALTH HAZARDS
Primary Routes of Exposure: Eyes: Yes Skin: Yes Inhalation: Yes
Eye Contact: May cause irritation and swelling.
SkinContact: May cause irritation and sensitization. Symptomscan be immediate or delayed several hours.
Inhalation: May cause irritation and temporary or permanent sensitization.
Ingestion: May cause irritation.
Other: Preexisting skin sensitization may be aggravated by exposure to this product.
4. FIRST AID MEASURES
Eyes: Flush eyes thoroughly with water for at least 15 minutes while holding eyelids open. Seek medical attention.
Skin: Remove contaminated clothing. Wipe excess from skin and wash the affected area thoroughly with soap and water. Wash
contaminated clothing thoroughly before reuse.
Inhalation: Remove to fresh air, and provide oxygen or artificial respiration if needed. Obtain medical attention; symptoms can be
delayed up to several hours.
Ingestion: DO NOT induce vomiting. Give 1-2 cups of water or milk unless the person is drowsy, convulsing, or unconscious. Get
medical attention.
5. FIRE FIGHTING MEASURES
Flammable Properties: Flash Point: >300 o F (PMCC)
ExplosiveLimits: Notapplicable Auto-IgnitionTemperature: Not applicable
Hazardous Decomposition Products: Carbon monoxide, carbon dioxide, aldehydes, and other organic substances.
EXTINGUISHING MEDIA AND FIRE FIGHTING INSTRUCTIONS : When sufficiently large quantities are present,
firefighters should be equipped with full bunker gear, including a positive pressure, NIOSH approved, self-contained breathing
apparatus. Extreme heat or water contamination may cause closed containers to explode.
Extinguishing Media: Use carbon dioxide, dry chemical or appropriate foam
6. ACCIDENTAL RELEASE MEASURES
Ventilate the spill area and evacuate if necessary. Remove all ignition sources. Dike and contain large spills. Clean-up personnel
should use adequate protective equipment.