Aeromotive 18668 - UNIVERSAL A1000 STEALTH PUMP ASSEMBLY User Manual
Important install requirements, Caution
18668 & 18669 Installation Instructions
IMPORTANT INSTALL REQUIREMENTS:
1. Must have at least a 4.5” diameter flat surface on the fuel tank to install this
pump.
2. Minimum vertical install height of 9.75”.
3. Pump can not be mounted horizontal (TOP MOUNT ONLY).
4. Baffling required at the pickup point for pump longevity and performance.
CAUTION:
Installation of this product requires detailed knowledge of automotive
systems and repair procedures. We recommend that this installation be carried
out by a qualified automotive technician.
Installation of this product requires handling of gasoline. Ensure you are
working in a well ventilated area with an approved fire extinguisher nearby.
Extinguish all open flames, prohibit smoking and eliminate all sources of ignition
in the area of the vehicle before proceeding with the installation.
When installing this product, wear eye goggles and other safety apparel as
needed to protect yourself from debris and sprayed gasoline.
The enclosed pump uses ORB ports, they are NOT PIPE THREAD and utilize NO THREAD
SEALANT. You must install ORB port fittings with o-rings to seal the fitting into the pump.
Kit includes:
1 x A1000 fuel pump
1 x Pump Retainer Ring
1 x Filter Assembly
1 x Pump Gasket
1 x ¾ tube
10 x Pump mounting bolts
10 x Teflon washer’s
2 x Retainer ring mounting screws
1 x 10AN ORB tube clamp
Aeromotive system components are not legal for sale or use on emission controlled motor vehicles.
The following steps are typical of most installations:
1. On the top of the fuel tank find a 4.5” diameter flat area for fuel pump location (towards the rear of the
tank is the best location). Mark the center of this location so it can be cut out.
2. Use a 3.5” hole saw to cut out the pump hole. Lower the pump into the hole and use a transfer punch
to locate the 10 mounting holes. Remove the pump and drill the holes using a .225” drill bit. Drill two
more holes for the pump retainer ring 180 degrees apart. Refer to figure 1-1 for these two holes.