AAEON AGD-317R - Manual (Page 25)

R e m o t e T o u c h D i s p l a y A G D - 3 1 7 R
Chapter 2 Hardware Installation 2-7
Monitor Arm or Wallmount Plate Installation
The LCD Display has Video Electronics Standards Association (VESA)
standard mounting holes tapped into the rear panel. The standard holes
are M4 set at 100mm x 100mm apart.
VESA Mounting Holes
To mount the LCD Display onto a monitor arm or wallmount plate, please
follow the steps below.
Step 1: Line up the threaded holes on the monitor rear panel with
the screw holes on the monitor arm or wallmount plate.
Step 2: Secure the monitor to the arm or stand with the retention
screws supplied with the monitor arm or stand.