X introduction x, X mechanical installation x – Liberty Pumps PRG-Series User Manual

Page 3

- 3 -

2. x

Introduction

INTRODUCTION

This manual was prepared to assist you in the correct installation, operation, and maintenance of your Liberty

pump. Please read it completely before installing the pump. Make certain that you are familiar with the contents,

and the chapters on installation and operation are fully understood before running the pump.

Liberty Pumps are designed for minimal maintenance. However, regular checks will ensure longer life and

greater operating reliability.

WARRANTY: No repair work should be carried out during the warranty period without prior factory approval. To

do so may render the warranty void.

SERIAL #: In all correspondence and reports, make certain that the pump serial number is given.

DESIGN OF PUMP

The grinder pump contains metal parts that rotate at high speeds. Be careful around

pump base while power is connected. Make sure that the pump is either in the tank or

clear from people and wires when in operation.

1. Liberty ProVore

Series grinder pumps are designed for continuous underwater operation. The motor and

pump form a close coupled, watertight unit. The induction motor is insulated against heat and moisture, Class

B insulation.

2. A thermal overload protector is imbedded in the stator windings. This is connected in series and wired to shut

down the pump if overheating occurs. The overload switch resets automatically when the motor cools.

3. The motor is protected against damage from water entry by a mechanical type cartridge seal with two silicon-

carbide faces.

4. The impeller and volute are designed for efficient flow characteristics and clog-free operation. The hardened

cutters grind solids and fibrous matter into small particles that can be safely pumped through small diameter

piping.

5. For sewage systems, consult local plumbing codes on requirements for venting the tank. The pump shall not

be installed in locations classified as hazardous in accordance with the National Electrical Code, ANSI/

NFPA70.

NOTE: The primary material of the Liberty PRG Series Pumps is cast iron, elastomers are Buna-N. They

should not be used to pump corrosive liquids.

Mechanical Installation

INSPECTION UPON RECEIPT

The shipping container should be immediately inspected for damage that may have occurred in shipment.

Exercise care in opening the shipping container to avoid damage to the pump. Remove any blocking and

cushioning from within the container.

Check all cushioning for spare parts before discarding. Visually check the pump and any spare parts for damage.

Check for damaged electrical wires, especially where they exit the motor housing. Contact the Liberty Pumps

Customer Service Department to report any damage or shortage of parts. The cutter located on the bottom of the

unit should be turned several rotations with the use of a 6 mm hex wrench, it should rotate freely without rubbing

on the cutter plate. This will insure that the impeller and cutter are free of any seizure due to prolonged storage.

If the impeller is not rotated manually prior to installation, the pump may fail to activate. If the impeller’s rotation is

difficult or completely resistant, contact the Liberty Pumps Customer Service Department.