beautypg.com

Gorman-Rupp Pumps PA4B60-4045H 1497876 and up User Manual

Page 36

background image

PA SERIES

OM−06228

MAINTENANCE & REPAIR

PAGE E − 16

Shaft And Bearing Removal And Disassembly

(Figure 4)

When the pump is properly operated and main-
tained, the shaft and bearing should not require
disassembly. Disassemble the shaft and bearing
only when there is evidence of wear or damage.

Shaft and bearing disassembly in the field
is not recommended. These operations
should be performed only in a properly-
equipped shop by qualified personnel.

After removing the drive components from the im-
peller shaft, remove the hardware (18 and 19) se-
curing the oil chamber plate (21) to the intermedi-
ate. Place a block of wood against the impeller end
of the shaft, and tap the shaft (15), bearing (25),
bearing retainer (23) and oil chamber plate out of
the drive end of the intermediate. Be careful not to
damage the shaft.

NOTE

There are no provisions for draining the grease
from the intermediate cavity. Place a drip pan under
the intermediate before removing the shaft and
bearing.

Remove the oil chamber plate, gasket (17) and
bearing retainer. Remove the O-ring (22) and, if
necessary, the retaining ring (20) from the oil
chamber plate. Remove the bearing retainer from
the shaft.

Press the oil seals (18 and 18A) from the intermedi-
ate bore.

After removing the shaft and bearing, clean and in-
spect the bearing in place as follows.

To prevent damage during removal from
the shaft, it is recommended that the bear-
ing be cleaned and inspected in place. It

is strongly recommended that the bearing
be replaced any time the shaft and bearing
are removed.

Clean the intermediate, shaft and all component
parts (except the bearing) with a soft cloth soaked
in cleaning solvent. Inspect the parts for wear or
damage and replace as necessary.

Most cleaning solvents are toxic and
flammable. Use them only in a well ven-
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain-
ers.

Clean the bearing thoroughly in fresh cleaning sol-
vent. Dry the bearing with filtered compressed air
and coat with light oil.

Bearings must be kept free of all dirt and
foreign material. Failure to do so will great-
ly shorten bearing life. Do not spin dry
bearings. This may scratch the balls or
races and cause premature bearing fail-
ure.

Rotate the bearing by hand to check for roughness
or binding and inspect the bearing rollers. If rota-
tion is rough or the rollers are discolored, replace
the bearing.

The bearing tolerances provide a tight press fit
onto the shaft and a snug slip fit into the intermedi-
ate. Replace the bearing, shaft, or intermediate if
the proper bearing fit is not achieved.

If bearing replacement is required, use snap ring
pliers to remove the bearing retaining ring (24)
from the shaft. Use an arbor (or hydraulic) press to
remove the bearing from the shaft.

Remove the inboard retaining ring (26) from the
shaft if required.