Gorman-Rupp Pumps PA6C60-QSB4.5P 1537244 and up - Manual (Page 15)

OM-06553 PAH SERIES
OPERATION PAGE C - 2
box to the “MANUAL” position, then press and hold
the “ENTER” button until the engine starts.
Pump speed and operating condition
points must be within the continuous per­
formance range shown on the curve on
Page E‐1.
Automatic Starting
With the float system installed, follow the proce­
dures outlined for manual starting and adjust the
throttle to the desired flow rate. Turn the key switch
to “OFF”, then move it to the “AUTO” position.
The pump will start automatically when the liquid
level in the sump or wet well increases and the
float(s) rise to the “on” position. An alarm will sound
and the control box will begin a countdown display
before the unit starts. When the liquid is sufficiently
pumped down, the unit will automatically shut
down.
The unit can be stopped while in the “AUTO” mode
by moving the key switch to the “OFF” position.
NOTE
If the key switch is moved to the “OFF” position
while in the “AUTO” mode, the engine will stop.
However, the auto‐start process will continue as
soon as the key switch is moved back to the “AUTO”
position.
The control panel is equipped with high oil temper­
ature, low oil pressure, engine overspeed and en­
gine overcrank safety shutdowns. If any of these
problems occur, the engine will not start. When the
problem is corrected, turn the key switch to the
“OFF” position to reset the control.
Priming
The pump will begin to prime upon startup. The air
in the suction line will be discharged from the educ­
tor discharge line. Complete priming is indicated
by a positive discharge pressure reading.
If full priming is not achieved, the discharge check
valve may be malfunctioning. If this occurs, shut
down the pump and consult the separate Mainte­
nance and Repair manual for further details.
Routine Operation
Do not operate an internal combustion
engine in an explosive atmosphere.
When operating an internal combustion
engine in an enclosed area, make sure
exhaust fumes are piped to the outside.
These fumes contain carbon monoxide,
a deadly gas that is colorless, tasteless
and odorless.
Adjust the engine speed to achieve the desired
output. Do not exceed the factory set engine speed
and system operating pressure. Do not operate
below the recommended operating speed (if appli­
cable).
Never tamper with the governor to gain
more power. The governor establishes
safe operating limits that should not be
exceeded. Refer to the performance
curve on page E-1 for the maximum
continuous operating speed for this
pump.
Operation In Extreme Heat
The safety shutdown system will automatically
stop the unit if engine operating temperature ex­
ceeds design limits. If engine over‐temperature
shutdown occurs, allow the unit to cool before re­
starting.
If engine overheating continues, check the engine
lubricant level and viscosity. Consult the engine
operation manual for the recommended lubricant
for operation in extreme heat.
If the unit is being operated in the automatic mode,
adjust the float(s) to allow shorter run and longer
cooling periods, if possible.