Gorman-Rupp Pumps 4D-X3 1P User Manual
Page 26
D SERIES
OM--01515
MAINTENANCE & REPAIR
PAGE E -- 10
PUMP AND SEAL DISASSEMBLY
AND REASSEMBLY
Review all SAFETY information in Section A.
Follow the instructions on all tags, label and de-
cals attached to the pump.
This pump requires little service due to its rugged,
minimum-maintenance design. However, if it be-
comes necessary to inspect or replace the wearing
parts, follow these instructions which are keyed to
the sectional views (see Figures 1, 2, 3 and 4) and
the accompanying parts lists.
As described on the following pages, this manual
will alert personnel to known procedures which re-
quire special attention, to those which could dam-
age equipment, and to those which could be dan-
gerous to personnel. However, this manual cannot
possibly anticipate and provide detailed precau-
tions for every situation that might occur during
maintenance of the unit. Therefore, it is the respon-
sibility of the owner/maintenance personnel to en-
sure that
only safe, established maintenance pro-
cedures are used, and that any procedures not ad-
dressed in this manual are performed
only after es-
tablishing that neither personal safety nor pump in-
tegrity are compromised by such practices.
Most service functions may be performed without
separating the pump and gearbox from the motor.
If major repair is required, the pump, gearbox and
motor must be disconnected.
Before attempting to service the pump, shut off in-
coming power to the motor and lock it out to ensure
that it will remain inoperative. Close all valves in the
suction and discharge lines.
For motor disassembly and repair, consult the lit-
erature supplied with the motor, or contact your lo-
cal motor representative.
Before attempting to open or service the
pump:
1. Familiarize yourself with this man-
ual.
2. Shut off incoming power to the mo-
tor and lock it out to ensure that the
pump will remain inoperative.
3. Allow the pump to completely cool
if overheated.
4. Close the discharge valve (if
used).
5. Drain the pump.
Before attempting to service the pump, drain the
pump by removing the drain plug (11, Figure 2).
Clean and reinstall the drain plug.
Suction And Discharge Check Valve Removal
(Figure 2)
To service the suction and discharge check valves,
remove the suction and discharge piping.
To service the suction check valve assembly (32),
remove the suction accumulator (3) by loosening
the hardware (8 and 9) securing it to the diaphragm
pot (1). Remove the hardware (5 and 6) securing
the valve seat (31) and check valve assembly to the
diaphragm pot. Pull the check valve assembly from
the suction port.
To service the discharge check valve assembly
(25), loosen the hardware (21 and 22) and remove
the assembled outboard discharge elbow (23),
check valve, and seat (24). Remove the gasket
(19).
Remove the hardware (16 and 17) securing the
valve seat (24) and discharge check valve assem-
bly to the discharge elbow.
To remove the inboard discharge flange (18), loos-
en the hardware (14 and 15) securing the flange to
the diaphragm pot. Remove the gasket (12).
The suction and discharge check valve assemblies
are identical parts and operate in the same direc-
tion. For removal and/or replacement, remove the
hardware (29, 30, 35 and 36) securing the check
valve weights (26, 28, 33 and 34) to the check
valves (27 and 37). Inspect and replace as re-
quired.
If no further disassembly is required, see
Suction
And Discharge Check Valve Installation.