Gorman-Rupp Pumps 612L20B-B 806819 and up User Manual
Page 25
60 SERIES
OM-01919
MAINTENANCE & REPAIR
PAGE E - 6
Remove the machine screws (12) and slide the
seal plate, seals and split packing gland off the
shaft as a unit. The rotating portion of the mechani
cal seal (3) will become a free part. Be careful not
to drop or damage the seal components when re
moving the seal plate.
To remove the packing seal, remove the lock nuts
(28), machine bolts (29), clips (34) and split pack
ing gland (35) from the seal plate. Use a stiff wire
with a hooked end to remove the packing from the
seal plate.
Use a dowel or other suitable tool to press the sta
tionary mechanical seal element, seat and O‐rings
out of the seal plate from the back side.
Use a screwdriver or other suitable tool to press or
pry the oil seal (42) out of the seal plate. Be careful
not to scratch or damage the seal plate bore.
If no further disassembly is required, see Seal
Reassembly and Installation.
Shaft and Bearing Removal and Disassembly
When the pump is properly operated and main
tained, the pedestal should not require disassem
bly. Disassemble the shaft and bearings only
when there is evidence of wear or damage.
Shaft and bearing disassembly in the field
is not recommended. These operations
should be performed only in a properly‐
equipped shop by qualified personnel.
Remove the pedestal drain plug (28) and drain the
pedestal. Clean and reinstall the plug.
Remove the hardware securing the pedestal (29)
to the base. Remove the shaft key (24).
Remove the hardware (21 and 22) and slide the
outboard bearing cap and oil seal (20 and 23) off
the shaft as a unit. Remove the bearing cap gasket
(19) and bearing adjusting shims (26). Tie and tag
the shims or measure and record their thickness
for ease of reassembly.
Press the oil seal out of the bearing cap.
Remove the hardware (13 and 14) and slide the in
board bearing cap and oil seal (15 and 31) off the
shaft as a unit. Remove the bearing cap gasket
(30).
Press the oil seal out of the bearing cap.
Place a block of wood against the impeller end of
the shaft and tap the shaft and assembled bear
ings (16 and 18) from the pedestal bore. Be care
ful not to damage the shaft.
After removing the shaft and bearings, clean and
inspect the bearings in place as follows.
To prevent damage during removal from
the shaft, it is recommended that bearings
be cleaned and inspected in place. It is
strongly recommended that the bearings
be replaced any time the shaft and bear
ings are removed.
Clean the pedestal, shaft and all component parts
(except the bearings) with a soft cloth soaked in
cleaning solvent. Inspect the parts for wear or dam
age and replace as necessary.
Most cleaning solvents are toxic and
flammable. Use them only in a well ven
tilated area free from excessive heat,
sparks, and flame. Read and follow all
precautions printed on solvent contain
ers.
Clean the bearings thoroughly in fresh cleaning
solvent. Dry the bearings with filtered compressed
air and coat with light oil.
Bearings must be kept free of all dirt and
foreign material. Failure to do so will great
ly shorten bearing life. Do not spin dry
bearings. This may scratch the balls or
races and cause premature bearing fail
ure.