beautypg.com

Gorman-Rupp Pumps 16C2-4045T 1514991 and up User Manual

Page 33

background image

OM-06541

10 SERIES

MAINTENANCE & REPAIR

PAGE E - 13

INSTALLATION OF FEDERAL MOGAL 5300W

OR NTN 3300 SERIES BEARINGS

(OPEN OR ENCLOSED IMPELLERS)

INSTALLATION OF MRC/SKF 5300M, 5300E OR

TIMKEN 5300W SERIES BEARINGS

(OPEN OR ENCLOSED IMPELLERS)

LOADING

DIRECTION OF

THRUST

BALL LOADING

GROOVE POSITIONED

AWAY FROM IMPELLER

GROOVE

DIRECTION OF

THRUST

LOADING

BALL LOADING

GROOVE POSITIONED

TOWARD IMPELLER

GROOVE

Figure 5. Inboard Bearing Positioning

After the bearings have been installed and allowed
to cool, check to ensure that they have not moved
away from the shaft shoulders in shrinking. If
movement has occurred, use a suitable sized
sleeve and a press to reposition the bearings
against the shaft shoulders.

If heating the bearings is not practical, use a suit­
able sized sleeve, and an arbor (or hydraulic) press
to install the bearings on the shaft.

When installing the bearings onto the
shaft, never press or hit against the outer
race, balls, or ball cage. Press only on the
inner race.

Slide the shaft and assembled bearings into the in­
termediate bore until the inboard bearing is fully
seated against the bore shoulder. Be careful not to
damage the lip of the oil seal (50) on the shaft
threads.

When installing the shaft and bearings into
the bearing bore, push against the outer
race. Never hit the balls or ball cage.

Apply a light coating of oil to the lip of the outboard
oil seal (43), and press it into the bearing cap (40)
with the lip positioned as shown in Figure 3. The
face of the oil seal should be just flush with the
outer face of the bearing cap.

Install the wavy washer (44) and bearing cap gas­
ket (37), and secure the bearing cap to the interme­
diate with the hardware (38 and 39). Be careful not
to damage the lip of the oil seal (43) on the shaft
keyway.

Lubricate the bearings as indicated in LUBRICA­
TION
at the end of this section.

Securing Intermediate And Drive Assembly To
Engine

(Figure 4)

Install the shaft key (41, Figure 3) in the shaft key­
way. Position the flexible portion of the coupling as­
sembly (3) on the shaft as shown in Figure 5.

NOTE

The flexible portion of the coupling must be proper­
ly positioned on the shaft. The heads of the caps­
crews in the center of the coupling must be posi­
tioned toward the pump end of the shaft
.

Align the keyway in the bushing (2) with the shaft
key, and slide it onto the shaft until it is just flush
with the end of the shaft. Rotate the flexible portion
of the coupling until the tapped holes for the two
setscrews align with those in the bushing, and in­
stall the setscrews.

Make certain that the flexible portion of the
coupling is mounted as shown in Figure 4.