beautypg.com

Gorman-Rupp Pumps 08C1-GA 1026171 and up User Manual

Page 31

background image

OM−01265

0 SERIES

MAINTENANCE & REPAIR

PAGE E − 11

ings. Bearings should never be heated with a di-
rect flame or directly on a hot plate.

NOTE

If a hot oil bath is used to heat the bearings, both the
oil and the container must be absolutely clean. If
the oil has been previously used, it must be thor-
oughly filtered.

Heat the bearings to a uniform temperature no
higher than 250

_F (120_C), and slide them onto

the shafts, one at a time, until they are fully seated.
This should be done quickly, in one continuous

motion, to prevent the bearings from cooling and
sticking on the shaft.

Use caution when handling hot bear-
ings to prevent burns.

NOTE

Position the bearing (37) on the shaft as indicated
by the following illustrations.

INSTALLATION OF NEW DEPARTURE OR

BCA/FEDERAL MOGAL 5300W SERIES BEARINGS

(OPEN OR ENCLOSED IMPELLERS)

INSTALLATION OF MRC/SKF 5300M OR

FAFNIR 5300W SERIES BEARINGS

(OPEN OR ENCLOSED IMPELLERS)

LOADING

DIRECTION OF

THRUST

BALL LOADING

GROOVE POSITIONED

AWAY FROM IMPELLER

GROOVE

DIRECTION OF

THRUST

LOADING

BALL LOADING

GROOVE POSITIONED

TOWARD IMPELLER

GROOVE

Figure 5. Double Row Bearing Installation

After the bearings have been installed and allowed
to cool, check to ensure that they have not moved
out of position in shrinking. If movement has oc-
curred, use a suitably sized sleeve and a press to
reposition the bearings.

If heating the bearings is not practical, use a suit-
ably sized sleeve and an arbor (or hydraulic) press
to install the bearings onto the shafts.

When installing the bearings onto the
shafts, never press or hit against the outer
race, balls, or ball cage. Press only on the
inner race.

Lay the gearbox housing on the bed of an arbor (or
hydraulic) press with the pump side down, and
support it so it is level and stable. Lubricate the in-

board drive shaft bearing (9) and slide it into the
gearbox housing bore until fully seated.

Install the woodruff key (10) in the shaft keyway.
Position the helical gear (11) against the inboard
bearing. Slide the drive shaft and assembled out-
board bearing into the gearbox housing. Align the
woodruff key with the gear keyway, and slide the
gear onto the shaft. Press the drive shaft into the
inboard bearing until fully seated. Install the cover
plate and gasket (23 and 24) and secure with the
capscrews (25).

Apply a light coating of oil to the lip of the oil seal
(17) and press it into the bearing cap (30) with the
lip positioned as shown in Figure 1. The face of the
oil seal should be just flush with the outer face of
the bearing cap.

Install the same thickness of bearing shims (31) as
previously removed. Install the bearing cap gasket
(14) and slide the bearing cap over the drive shaft,