beautypg.com

Gorman-Rupp Pumps 08C1-GA 1026171 and up User Manual

Page 27

background image

OM−01265

0 SERIES

MAINTENANCE & REPAIR

PAGE E − 7

SEAL
SPRING

SHAFT

KEY

IMPELLER

SHIMS

IMPELLER

RETAINER

O-RING

STATIONARY

SEAT

IMPELLER

SHAFT

PUMP CASING

BELLOWS

ROTATING

ELEMENT

Figure 2. 25271−903 Seal Assembly

This seal is not designed for operation at
temperatures above 160

_

F (71

_

C). Do not

use at higher operating temperatures.

Inspect the pinion shaft (35) for distortion, nicks,
scratches, or damage to the shaft keyway. Dress
small nicks or burrs with a fine file or emery cloth. If
excessive wear exists or the shaft is defective, refer
to GEARBOX DISASSEMBLY and replace the
shaft.

Lubricate the stationary seat O-ring with light oil
and install it in the stationary seat. Use thumb pres-
sure to press this subassembly into the pump cas-
ing until fully seated. Be careful not to damage the
seal face. After installation, wipe the seal face in a
concentric pattern with a clean, lint-free cloth to re-
move any fingerprints.

NOTE

It is recommended that a tapered sleeve (see Fig-
ure 3) be installed over the shaft keyway to ease in-
stallation of the rotating portion of the seal. This tool
can be made from steel tubing or black pipe.