Extron Electronics VTG 300_300R User Guide Rev. D - Manual (Page 12)

VTG 300/300R • Operation VTG 300/300R • Operation
Operation, cont’d
2-11
RGB Sync format submenu (RGB Sync Fmt)
The VTG offers a choice of four RGB sync formats. Press any
or button to select from among the formats:
• RGBHV (default)
• RGBS
• RGsB
• RsGsBs
Raster border submenu (RasterBorder)
A white border may be placed around the active area of a video
signal. Press any or button to enable (On) or disable (Off)
the border:
• On
• Off (default)
Advanced Setup menu
The following flowchart provides an overview of the Advanced Setup
menu.
Extron
VTG 300
ADVANCED
SETUP
MENU
NEXT
PwrOff Timer
15 min
NEXT
NEXT
ScrSvr Timer
Disabled
NEXT
NEXT NEXT
NEXT
Enable@PwrUp
Last Used
BackLight
Off
Press & Hold
& to reset
Power Off Timer
• Disabled
• 5 minutes
• 15 minutes (default)
• 30 minutes Screen Saver Timer
• Disabled (default)
• 5 minutes
• 10 minutes
• 15 minutes
Enable Outputs at Power Up
• Last Used (default)
• Vid Only
• Aud Only
• Aud+Vid Enable BackLight*
• Off (default)
• On Unit Reset
• Simultaneously press and
hold any of the three and
button pairs for two seconds
to reset the VTG to factory
default settings.
ScrSvr Mode
CYCLE
Select Screen Saver
• Blank - black screen
• Cycle - cycles through all
six test pattern categories
*This menu is displayed only when
the VTG is powered by batteries.
Figure 2-6 — Advanced Setup menu
Power off timer submenu (PwrOff Timer)
When enabled, this feature allows the VTG to be automatically
powered off after a certain period of button inactivity has
elapsed. This power off feature conserves battery power.
When the VTG is powered by the external power
supply, this power off feature is disabled.
2-10
Output 3 submenu
Output 3 may be set to output audio through the left and/or
right channel(s).
Press any or button to select the audio output from
Output 3’s phono jack:
• Left and right channel (default) — output audio from
both left and right channels of Output 3.
• Right only — output audio from the right channel and
disable the left channel, and disable Output 1 (RCA)
and Output 2 (XLR).
• Left only — output audio from left channel only and
disable the right channel.
Video Setup menu
The following flowchart provides an overview of the Video
Setup menu.
Extron
VTG 300
VIDEO
SETUP
MENU
NEXT HD15 Format
RGB
NEXT
NEXT RGB Sync Fmt
RGBHV
NEXT
RasterBorder
On
HD15 Video formats
• RGB (default)
• Y, R-Y, B-Y
RGB Sync formats
• RGBHV (default)
• RsGsBs
• RGsB
• RGBS
Raster Border
• On
• Off (default)
Figure 2-5 — Video Setup menu
HD15 Video format submenu (HD15 Format)
There are two video formats that can be output from the 15-pin
HD connector.
Press any or button to select from among the formats:
• RGB (default)
• Y, R-Y, B-Y