beautypg.com

Prior to first use of ice/water dispenser – Beko GNE V422 X User Manual

Page 18

background image

EN

18

To fit the water filter follow the
instructions below referring to figures
supplied:

1. Press ice cancel button on the

display. (Figure 1)

2. Remove the filter cover in the fridge

compartment by pulling it forward.
(Figure 2)

3. Take out the water filter by-pass

cover by rotating it downwards.
(Figure 3-4)

A

Warning: Make sure that the “Ice

off” mode is active before taking out
the by-pass cover.
Note: It is normal that a few drops of
water drip after the cover has been
taken out.
4. Remove the lid on top of the water

filter to place it as shown in the figure
and turn upwards to lock it. (Figure 5)

5. Press ice cancel button on the

display again to exit from this mode.

Water filter should be replaced every
6 months. The water filter must be
removed as shown in the figure when
it is going to be replaced or when it will
no longer be used and by-pass cover
must be attached. It must be made
sure that Ice Off mode is active before
taking it out.

A

Warning: Water filter cleans some

foreign particles in the water. It does
not purify water from microorganisms.

A

Warning: Ice Off button must

always be pressed during replacement
of the water filter or installing the by-
pass cover.

Prior to first use of Ice/Water

Dispenser

C

Water mains pressure must not be

below 1 bar.

C

Water mains pressure must not be

over 8 bars.