Extron Electronics SW YUV A Series User Guide - Manual (Page 9)

1-3 SW RGB and YUV A Switchers • Introduction
Features
Audio switching models
Inputs — These switchers input 2, 4, or 6 stereo audio signals, balanced or
unbalanced, on 3.5 mm, 5-pole captive screw terminals.
Outputs — The selected audio input is buffered and output, balanced or
unbalanced, on a 3.5 mm, 5-pole captive screw terminal.
Audio gain/attenuation — Users can set the input level of audio gain or
attenuation (-18 dB to +24 dB) via the RS-232 link or from the front panel, to
be compatible with a wide range of line level (from -20 dBV to +4 dBV).
Individual input audio levels can be adjusted so there are no noticeable
volume differences between sources (figure 1-2) and for the best headroom
and signal-to-noise ratio. This function also eliminates the need for separate
preamps or attenuators when used with professional (higher line level) and
consumer (lower line level) audio equipment.
Audio
Inputs
Audio
Inputs
Consumer VCR
No Noticeable Volume
Differences Between Sources
Audio System
Pro CD Player
+2
-1
-3
-7
-10
-14
Low Audio
Output Level
+5
+8
+4
+1
-2
-5
-8
-12
+7
+10
+2
-1
-4
-7
-10
-14
Output
Level
+5
+8
+4
+1
-2
-5
-8
-12
+7
+10
dBv dBu
High Audio
Output Level
dBv dBu
+2
-1
-3
-7
-10
-14
+5
+8
+4
+1
-2
-5
-8
-12
+7
+10
dBv dBu
SW RGBHV A Series Switcher
SW6 RGBHV A
RGBHV & AUDIO SWITCHER
AUDIO
CONF/SAVE
6 5 4 3 2 1 AUTO SWICH
ACTIVE -dB +dB
Figure 1-2 — Audio gain and attenuation
Audio follow — Audio can be switched with the corresponding video input.
Audio follow switching can be done via front panel control or under RS-232
remote control.
Audio breakaway — Audio can be broken away from its corresponding video
input signal. Audio breakaway switching can only be commanded under
RS-232 remote control.
All switchers
RGB video models
Inputs — The video switchers input up to 2, 4, or 6 RGB video signals on five
female BNC connectors.
Outputs — The selected RGB video input is output on five female BNC connectors.
Component video (SW6 YUV A)
Inputs — The switcher inputs up to 6 component video (Y, R-Y, B-Y) signals on
three female BNC connectors.
Outputs — The selected component video input is output on three female BNC
connectors.