Extron Electronics MTP 1500RL 15HD A SEQ Setup Guide - Manual

MTP 1500RL 15HD A SEQ • Setup Guide
This guide provides basic instructions for an experienced installer to set up and operate the Extron MTP 1500RL
15HD A SEQ twisted pair receiver.
For full details, see the MTP 1500RL 15HD A SEQ User Guide, available online at www.extron.com .
MTP 1500RL Series
POWER
12V
1.0A MAX
MTP 1500RL 15HD A SEQ
OUTPUT
MONO
L R
AUDIO
RGB
PEAKING LEVEL
DELAY
RED
GREEN
BLUE
SELECT
ADJUST MIN/MAX
INPUT BUFFERED OUTPUT
ON
H
+
V
+
CSYNC SO
G
VIDEO END SP
ARE
MTP MTP
Installation and Setup
Step 1 — Mounting
Turn off or disconnect all equipment power sources. Mount the MTP 1500RL 15HD A SEQ receiver as required.
Step 2 — Connect Input
Connect the RJ-45 cable from an MTP transmitter to the Input port on the MTP 1500RL 15HD A SEQ receiver.
Terminate the cable as shown below right, using the same standard (A or B) at both ends.
NOTE: The transmitter and receiver are designed for and perform best with Extron Enhanced Skew-Free AV cable terminated in accordance
with the TIA/EIA T568A standard. CAT 5 cables are acceptable but less preferable. Using preterminated and tested cables is also
recommend, Cables terminated on site should be tested before use to ensure that they comply with Category 5 specifications.
Step 3 — Connect Outputs
Attach the applicable output cables (video, audio, and buffered output).
A. High resolution video output — Connect a display device to the 15-pin HD connector (RGB).
B. Audio connector — Connect an audio device to the 5-pole captive screw connector for mono audio output
1
MONO AUDIO
2
1
MONO AUDIO
2
Unbalanced Output Balanced Output
Do not tin the wires!
Mono output 1-
Sleeve(s)
Mono output 1+
Mono output 2+
Mono output 2-
Sleeve(s)
Mono output 1
Mono output 2
NO GROUND.
NO GROUND.
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT connect the sleeves to the negative (-) contacts.
C. Buffered output — Connect up to 5 daisy-chained MTP receivers to this RJ-45 connector.
Insert Twisted
Pair Wires
Pins:
RJ-45 Connector
12345678
Pin T568A Wire
Color T568B Wire
Color
1 White-green White-orange
2 Green Orange
3 White-orange White-green
4 Blue Blue
5 White-blue White-blue
6 Orange Green
7 White-brown White-brown
8 Brown Brown