Extron Electronics DVI 110 User Guide - Manual (Page 11)

DVI 110 • Installation 5
Pin Signal Pin Signal Pin Signal
1 TMDS data 2– 9 TMDS data 1– 17 TMDS data 0–
2 TMDS data 2+ 10 TMDS data 1+ 18 TMDS data 0+
3 TMDS data 2 11 TMDS data 1 19 TMDS data 0
shield shield shield
4 Spare 12 Spare 20 Spare
5 Spare 13 Spare 21 Spare
6 DDC clock 14 +5 V power 22 TMDS clock
shield
7 DDC data 15 Ground (+5 V) 23 TMDS clock+
8 CEC control 16 Hot plug 24 TMDS clock–
detect
1 8
17 24 9
Female Connector Male Connector
16
Figure 5. DVI Connector Pin Assignments
c
DVI-D input connector — Plug the cable from the source device into this single
link format female DVI connector. The table above shows the DVI pin configuration.
NOTE: Although this is actually a DVI-I connector, its analog pins are not enabled.
Only DVI-D signals are accepted.
d
Power connector — Plug the external 12 V power supply (provided with the unit)
into this 2-pole captive screw connector. The figure below shows how to wire the
connector.
Power Supply
Output Cord
Captive Screw
Connector
SECTION A–A
Ridges Smooth
A A
Tie Wrap
3/16” (5 mm) Max.
Figure 6. Wiring the Power Connector
WARNING: Keep the two power cord wires separate while the power supply is
plugged in. Remove power before continuing.