Installation – Extron Electronics DVS 406 SDI Input Card User Manual
Page 2
DVS 406 SDI Input Card • Installation
DVS 406 SDI Input Card • Installation
Installation
3
2
Installing the SDI Connector Card
The SDI connector card may be installed in the DVS 406 by
following the instructions and illustrations shown below.
Internal access
To gain access to the internal components, do the following:
1.
Remove the power cable from the DVS 406 and from the
power source.
Do not open the cover of the scaler without
unplugging the power cord.
2.
If the DVS 406 scaler is rack mounted, remove the input and
output cables from it and remove the unit from the rack. If
the scaler is not rack mounted, you do not need to remove
the input and output cables.
3.
Remove 13 screws from the top and sides of the cover
(figure 1).
Fig. 1 — Removing the cover
4.
Remove the cover by slightly lifting each side alternately
until the cover is free.
Reverse this procedure to reinstall the cover after the SDI
connector card has been installed.
CAUTION
Do not touch any switches or other electronic
components inside the scaler. Doing so could damage
the scaler. Electrostatic discharge (ESD) can damage
IC chips even though you cannot feel it. You must be
electrically grounded. A grounding wrist strap is
recommended.
Card installation
After following the instructions in “Internal access” to remove
the cover, do the following:
1.
Locate the SDI card standoff located near the middle rear
portion of the main circuit board (looking from above with
the front panel nearest to you).
Fig. 2 — SDI card standoff and connector opening
2.
Remove the plastic cap covering the SDI connector opening
from the rear panel of the scaler, and position the SDI card
at an angle with the SDI connector protruding from the rear
SDI connector opening.
3.
The SDI card has a 20-pin socket on the underside which
must align with the 20 pins on the main circuit board. Be
sure to align the pins properly, in order to prevent bending
the pins, before pressing the SDI card firmly in place against
the standoff. The mounting hole on the SDI card should
now be directly over the standoff.
Fig. 3 — SDI card situated above pins and standoff
NE
XT
ME
NU
PICTURE ADJUSTMENTS
DIGITAL VIDEO SCALER
4
2
1
3
5
6
VID
EO
/
S-V
ID
EO
RG
B/Y
UV
RG
B
VID
EO
/
S-V
ID
EO
VI
DE
O/
S-
VID
EO
SD
I
TA
KE
CO
L/T
NT
BR
T/C
ON
T
DE
TA
IL
SIZ
E
CE
NT
ER
DV
S 4
06
AD
JU
ST
Lift Cover
Straight Up
Remove (13)
screws from
top and sides
SDI connector opening
SDI card standoff
20-pin socket on
back of SDI card
20-pin connector
on main board