Extron Electronics DVS 406 SDI Input Card - Manual

User’s Guide
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2002 Extron Electronics. All rights reserved.
70-168-01 Upgrade Kit
68-619-01 Rev. B
Printed in the USA
08 02
DVS 406 SDI Input Card
4. Insert the card’s installation screw through the SDI card’s
mounting hole, and gently tighten it into the standoff.
Fig. 4 — SDI card mounted in place
5. Install the SDI connector’s hex nut from the outside of the
rear panel opening. Keep the SDI card from twisting as the
nut is tightened.
6. Replace the top cover on the DVS 406 scaler, and fasten it
with the screws which were removed in step 3 of the
“Internal access” section.
7. Rack/furniture mount the scaler, and reconnect the AC
power cord.
Part Numbers
Extron Part Part Number
SDI Input Card Kit 70-168-01