Power cable connections, Applying power, Extron contact information – Extron Electronics DVI DA4 Setup Guide User Manual
Page 2: Dvi da2 and dvi da4 setup guide (continued), Step 3 — power cable connections, Step 4 — applying power
68-1376-50
Rev C
04 10
DVI DA2 and DVI DA4 Setup Guide (Continued)
Step 3 — Power Cable Connections
Connect the 12 VDC power supply to the power receptacle of the unit.
12V
0.4A MAX
POWER
Power Supply
Output Cord
SECTION A–A
Ridges
Smooth
A
A
DC Power Cord
Captive Screw Connector
AC Power Cord
Ground
+12 VDC
External
Power Supply
(12 VDC, 1 A )
CAUTION: This product is intended to be supplied by a Listed Power Unit marked “Class 2” or “LPS”,
rated 12 VDC, maximum 1.0 A. Always use a power supply supplied or specified by Extron. Use
of an unauthorized power supply voids all regulatory compliance certification and may cause
damage to the supply and the end product.
Unless otherwise stated, the AC/DC adapters are not suitable for use in air handling spaces or
in wall cavities. The power supply is to be located within the same vicinity as the Extron A/V
processing equipment in an ordinary location, Pollution Degree 2, secured to the equipment rack
within the dedicated closet, podium, or desk.
The installation must always be in accordance with the applicable provisions of National Electrical
Code ANSI/NFPA 70, article 75, and the Canadian Electrical Code part 1, section 16. The power
supply shall not be permanently fixed to building structure or similar structure.
NOTES: The length of the exposed wires in the stripping process is critical. The ideal length is
3/16 inches (5 mm). If the exposed section is longer, the exposed wires may touch, causing a short
circuit between them. If it is shorter, the wires can be easily pulled out even if tightly fastened by
the captive screws.
Do not tin the wires. Tinned wire does not hold its shape and can become loose over time.
Step 4 — Applying Power
NOTE: Output 1 is used as DDC reference and Hotplug Detect and a local monitor must be
connected to it before the source device is powered on. Since Output 1 is used for reference, all
displays connected to the other outputs must be capable of handling resolutions greater than or
equal to that of Output 1.
•
Power on the local monitor.
•
Power on the display devices.
•
Power on the source input device.